Cummins Powered 250kw Diesel Generator Price (NTA855-G1B) (GDC250*S)

Cummins Powered 250kW diesel generator price (NTA855-G1B) (GDC250*S)

Engine brand: Cummins
Model: NTA855-G1B
Cylinder arrangement: Natural Aspirated
Cycle: Four stroke
Aspiration: Turbocharged and Water/Air cooling
Speed Governor Electronic
Cooling System Forced Water Cooling Cycle
Starting Method DC24V electrical starting

Alternator brand: Stamford Copy Alternator
Model: JDG314
Number of Phase: 3P
Connecting Type: 3 Phase and 4 Wires
Number of Bearing 1
Protection Grade IP23
Exciter Type Brushless, Self-exciting, AVR automatic voltage regulating, 100% Copper winding wire
Insulation Class: H.
Control Panel
It includes:
1. Automatic cutter which is suitable for the generator power
2. Turn on key
3. A device to measure the generators speed
4. Counter for measuring the Operating hours
5. Device to measure the current overload with a switched current
6. A device to measure the battery voltage
7. Voltmeter with a voltage exchanger
8. A device to measure the frequency
9. Thermostat to regulate the voltage
10. A device to measure the oil pressure
11. Alerting lamps indicating low and high temperature
12. Controller of the current increase and short circuit
13. Emergency stop button

Sound proof canopy: 
1)with steel sheet
2)Stainless steel locks
3)Control panel viewing window for monitoring the status of the generator set
4)Good ventilation system and anti-heat radiation construction
5)Effective anti-vibration devices to ensure the generator set run steadily
6)Super silent materials inside to ensure the noise lower than 70 dB 7 meters away
7)Emergency stop button mounted outside
8)Side lockable door easy for maintenance and installation
9)Lube oil and cooling water drains piped to exterior of the canopy

Our Advantages: 
1. Solve your technical problems in 24 hours and provide international warranty service for engines
2. Design the appearance form according to customers' request
3. Polyester varnish for appearance protecting for shining and raining
4. Two hours testing before out factory
5. ISO9001 and CE certification

Factory Inspection, the test items before delivery are mainly as follows: 
1. Each genset should be put into commission more than 4 hours totally. They are tested on idle load, fully load and 10% overload. 
2. The noise level is be tested. 
3. All the metres on the control panel should be tested
4. The appearance of the gensets and all of the label and nameplate shall be checked.  Generator photos: